The Sachs Engine Kit can be easily installed onto 

 Sachs Motor Kit Fitting Instructions

1. Remove right and left hand brakes and grips.

2. Assemble controller and accelerator by fitting cables to controller. Fit accelerator cable by pulling back handgrip rubber and placing cable end into the slot on inside section of grip. Remove the lid on control switch and place choke cable into slot inside lever.

3. Shift control switch into centre position. Locate cable and accelerator tube in groove of control switch and push both onto handlebars.
   (Note: If accelerator tube is not located in controller groove you will not be able to push it onto handlebars, or you will damage location grooves if forced).
   

4. Fit rear brake cable, fit controller cable by removing screw and cover on top of controller. Clip in cable, replace cover and screw.

5. Fit rear tyre and tube to rim.

6. Fit rim to motor by locating splines and simply push wheel onto motor. Fit single gear sprocket.

7. Remove existing rear wheel and fit power assisted rear wheel to cycle.

8. Fit rear pack-rack to cycle, clip in tank and secure with straps, fit fuel line to tank and motor.

9. Fit bracket supplied and suitable bolt to front arm on exhaust.

10. Align rear wheel and sandwich bracket between cycle stand and frame. Re-tighten bolts.

11. Fit cable to handbrake, accelerator and control lever (Note: Adjust cables after fitting)

12.  Fit cable ties to secure control cables to frame of cycle.

13. Fit left hand brake lever. (Provided for a matching look)

14. Ensure motor is full of oil (Castrol EPX 80W/90 or refer owners manual for different grades of oil).

15. Place control lever in the cold start position, accelerate slightly, pull starter a few times and engine will start. Push control lever back to centre position after 20-30 seconds of running.

 Your Sachs Motor should now be ready for a test run.

For any further information refer to or owner’s manual or contact Motorised Bicycles Australia Pty. Ltd. 
(02) 9882-BIKE (9882.2453) or fax to (02) 9882-6966

  For Australian conditions, we advise you use the following fuel mixture:

100mls Shell two-stroke oil to 5 litres Premium Unleaded fuel, or 20mls per litre.

  Please note that the motor will require an 8 to 10 hour initial running-in period.

  This Motor will be fully run in after 50 to 80 Hours of use and a marked increase in power and performance will be noticed.

  In short – The More You use it the better it will be.

Please Note: Motors Not Fitted By an Authorised Sachs Dealer Void Their 6 Month Warranty